CIRCUIT ADJUSTMENT MODE
On this model, the following adjustment items are performed using theremote hand unit:
* Item 3 (Cut Off)~Item 5 (Raster Size)
* Item 8 (White, Brightness)
~ Item 11 (Screen Character Position)
To perform these adjustments using remote hand unit, set the productto the circuit adjustment mode beforehand. use the following procedure toactivate the circuit adjustment mode.
1. Change to the Circuit Adjustment Mode
1. Press the "TEST" button on the remote hand unit. the builtin cross-hair pattern will appear.
2. Press the "1", "1", and "8" on the remotehand unit in that order and change to the circuit adjustment mode. The displayas shown on the right will appear.
NOTE: Repeat the step 1 to 2 when not changing to the circuitadjustment mode.
2. Selection of Adjustment Functions and AdjustmentItems
To select an adjustment item in the circuit adjustment mode, select firstthe adjustment function, that includes the specific adjustment item to beselected, and next select the adjustment item.
1. Press the "R/B" button to select an adjustment function.Each time the button is pressed, the adjustment function changes as follows;
HOUR-TIMER--->CONV--->ATC--->HR--->DAC--->HOUR-TIMER....ETC.
2. Press the "up" or "down" button on the remotehand unit to select a specific item.
* Press the "up" button. The adjustment item number will increase.
* Press the "down" button. The adjustment item number will decrease.
3. Changeing Data
1. After selecting an adjustment item, press the "left" or"right" button to change the adjustment data.
* Press the "left" button. The adjustment data will decrease.
* Press the "right" button. The adjsutment data will increase.
2. Press "ENTER" to save the adjustment data in memory. Thescreen characters turn red for approximately 2 to 3 seconds in this step.
4. Terminating the Circuit Adjustment Mode
Press the "TEST" button on the remote hand unit to terminatethe circuit adjustment mode.
NOTE: The circuit adjustment mode can also be terminated by turningthe power off.